The desired settings and the size of the system is programmed by F-link SW. It offers exible setting and allows easy protection for small premises, bigger family houses, of ces and companies. Close the cover of the detector with the installed module. The JA-101K control panel is a basic component of the JABLOTRON JA-100 alarm system. Press the tamper contact in the detector (or briefly connect the blue and black module wires together) – the module is thusenrolled and the yellow LED indicator goes off.ĥ. Go to the F-Link program, select the required position in the Detectors window and launch the enrollment mode by clicking on Enroll option.Ĭ. pozornní: Zabezpeovací systém JABLOTRON 100+ je uren výhradn k montái prokoleným montáním technikem, který má platný certifikát Jablotronu Alarms a.s. Pi pouití jiných prvk nelze zaruit správnou funkci systému a stupe zabezpeení. When the device is switched on, the yellow LED (3) starts flashing repeatedly to indicate that the module has not beenenrolled into the system.ī. je doporueno pouívat pouze periferie ady JABLOTRON 100+. Proceed according to the control panel installation manual. Jablotron JA-111H Bus module for the connection of a detectorFigure:ġ – bus terminal board 2 – production code 3 – yellow fault indicator 4 – red indicator is used to indicate activation of alarm or tamper input with a flashĤ.
Connect the wires to the detector (according to Fig.
F link jablotron install#
Install the module at a suitable place in the detector.>Ģ. The module has a status reaction (reports its activation and deactivation). JA-111H is a module that enables you to connect any wire from the sensor to the system BUS.
0 kommentar(er)
